Nutanix NCM-MCI-5.15 問題集

質問 1：
Refer to the exhibit.

User 1 and User 2 belong to the AAPM group
What are two descriptions of how Files perform quota management? (Choose two.)
A. User 1 can add an 8GB file to the share without receiving notification.
B. User 2 can continue to add another 3GB file but will receive a daily notification email.
C. User 1 can continue to add another 5GB file but will receive a daily notification email.
D. User 2 can add an 8GB file without receiving a notification email.
正解：C,D
解説: (Topexam メンバーにのみ表示されます)

質問 2：
A customer recently set up Async Replication between Site A and Site B. The customer wants to conduct a planned failover and clicks Activate on Site B.
The customer then runs the following command on Site A:
ncli pd deactivate_and__destroy_vms name=<protection_domain_name>
What does this do to the customer environment?
A. VMs get deleted from Site A and the protection domain is no longer active.
B. VMs are powered off on Site A and must be manually powered on at Site B.
C. VMs get deleted from Site B. and the protection domain is now Active.
D. Customer must then manually power off VMs at Site A and power them on at Site B.
正解：A
解説: (Topexam メンバーにのみ表示されます)

質問 3：
An administrator is supporting a business critical environment and deploys metro availability to achieve a zero data loss configuration. The two clusters are connected by a 1GbE connection. A new workload is going to be deployed to this cluster. This workload requires a sustained 150MB/S of write throughput and 20MB/s of read throughput.
Which change must be made to deploy the workload successfully on this cluster?
A. Zero data loss nearsync must be used to support this workload.
B. The workload must be configured to read at greater than 12.5MB/S.
C. The replication frequency must be less than 60 minutes.
D. The bandwidth must be increased to support this workload.
正解：D
解説: (Topexam メンバーにのみ表示されます)

質問 4：
An administrator needs to make sure an RF3 cluster can survive a failure of two complete racks without negatively affecting performance. The current cluster configuration consists of the following:
* 30 All Flash Nodes: distributed 10 nodes per rack across three 42U racks
* Each node is configured with 20TB usable storage all flash (Cluster Total 600TB Usable)
* Current cluster utilization is 500TB storage
* Storage containers have Erasure Coding enabled
Which configuration changes should be made to make sure the cluster meets the requirements?
A. Expand the cluster to 48 nodes distributed evenly across 6 racks
B. Expand the cluster to 40 nodes distributed evenly across 5 racks
C. Expand the cluster to 50 nodes distributed evenly across 5 racks
D. Expand the cluster to 60 nodes distributed evenly across 6 racks
正解：D
解説: (Topexam メンバーにのみ表示されます)

質問 5：
A customer with a four-node RF2 cluster is adding application VMs to their system. After adding these VMs, the Prism dashboard shows 81% storage utilization.
What is the consequence of running the cluster at 81% storage utilization?
A. Node failure is imminent due to storage utilization.
B. The customer has the ability to add more VMs up to the 100% storage utilization.
C. The cluster is not resilient in the storage fabric
D. There is available capacity in the storage fabric and the cluster is resilient.
正解：C
解説: (Topexam メンバーにのみ表示されます)

質問 6：
A VM does not have enough resources for the demand, which leads to performance bottlenecks. The VM is exhibiting one or more of following baseline values, based on the past 30 days:
* CPU usage > 90% (moderate), 95% (high)
* CPU ready time > 5%, 10%
* Memory usage > 90%, 95%
* Memory swap rate > 0 Kbps (no moderate value)
Which type of VM is being described?
A. Bully VM
B. Inactive VM
C. Constrained VM
D. Over-provisioned VM
正解：C
解説: (Topexam メンバーにのみ表示されます)

質問 7：
For several days, an administrator notices the following alerts:
* CVM NIC Speed Low Warning Alerts
* Warning Alerts of CVM NIC not performing at optimal speed
* CVM is disconnected from the network Critical Alert
* Network Visualization page shows excessive dropped packets on CVM/Host Which steps should be taken to determine which problem should be addressed first?
A. * Verify Host/CVM connectivity on the Network Visualization page
* Use to verify the bridge and bond configuration
* Review alerts/events page for the CVM disconnected error
B. * Review Alerts page for NIC speed alerts and alert timing
* Analyze the genesis.out log file for process failures
* Assess the NIC properties in the Network Visualization > Host Properties page
C. * Restart networking services on the CVM
* Determine the current configuration of the affected CVM via output
* Access the Alerts/Events page for the CVM network connection failures
D. * Access the Hardware Page to verify resources are available
* Analyze ail CVM Speed Alerts in the Alerts/Events page
* Analyze output for the network and interface properties and connectivity issues
正解：A
解説: (Topexam メンバーにのみ表示されます)

質問 8：
A customer has two mission-critical applications and needs to have them backed up to a remote location. The remote location is connected using a leased line and has an average latency of 7 ms.
Which Nutanix technology will provide the shortest RPO possible?
A. Asyn&DR
B. NearSync
C. Leap
D. Metro Availability
正解：C
解説: (Topexam メンバーにのみ表示されます)

質問 9：
Refer to the exhibit.

An administrator receive the warning massages shown in the exhibit while validating cluster conversion from EXSi to AHV.
What should the administrator do to address this warning in v Center Server?
A. Keep active adapters od different speeds as active standby
B. Remove the standby adapters under Teaming and Failover.
C. Keep homogeneous adapter as active and standby
D. Remove adapters that are active but not homogeneous.
正解：C