VMware 3V0-41.19 問題集

質問 1：
An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.
During discussions about Centralized Services NAT running on Tier-1 or Tier-0 LR the customer made these requests:
* Services contain stateful services.
* Services should be in high availability mode.
Which two should the architect include in their design? (Choose two.)
A. Mix stateful and stateless NAT rules on the same LR.
B. Use only DNAT rules in stateful NAT.
C. NAT should be applied on the uplink Interface.
D. An active/active model should be used.
E. The high availability mode supported is only Active-Stand by.
正解：B,E
解説: (Topexam メンバーにのみ表示されます)

質問 2：
Which two VMware recommendations should an architect follow when configuring top of rack (ToR) switches in an NSX-T Data Center environment? (Choose two.)
A. Configure switch ports that connect to ESXi host manually as trunk ports.
B. Modify the Spanning Tree Protocol to increase the time to transition to the forwarding state.
C. Configure redundant physical switches to enhance availability.
D. Use only IPv4 addressing in all deployments.
E. Configure switch ports with a Dynamic Trunking Protocol.
正解：A,C
解説: (Topexam メンバーにのみ表示されます)

質問 3：
Refer to Exhibit.

To meet the technical requirements for NSX Edge VM, which two design choices are required to satisfy this architectural design. (Choose two.)
A. ESXi host should be prepared as a Transport Node and use VLAN backendsegments to connect Edge Node Interfaces.
B. vmk ports need to be on VDS instead of N-VDS, with one pNIC for each virtual switch providing greater functionality.
C. ESXi host must have more than 2 pNICs available to create another N-VDS. D NSX Edge should run as a physical device.
D. NSX Edge TEP and ESXi TEP need to be in different VLANs.
正解：A,D
解説: (Topexam メンバーにのみ表示されます)

質問 4：
Refer to the exhibit.

A financial company is adopting micro-services with the intent of simplifying network security. An NSX-T architect is proposing a NSX-T Data Center micro-segmentation logical design. The architect has created a diagramto share with the customer.
How many security levels will be implemented according to this Logical Design?
A. 6 levels
B. 2 levels
C. 4 Levels
D. 9 Levels
正解：C
解説: (Topexam メンバーにのみ表示されます)

質問 5：
An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.
Thisinformation was gathered during a workshop about ESXi Host networking:
* A total of 50 ESXI hosts to be configured as Transport Nodes.
* All ESXi hosts have a dedicated 2 x Intel 10Gbps Physical Network adapter for the Overlay Traffic.
To achieve lowlatency, high throughput, redundancy, and performance, which two NIC teaming policies should the architect recommend? (Choose two.)
A. Load Balance Source
B. Load Balance Source MAC
C. Load Balance Source Port ID
D. Load Balance Port ID
E. Failover Order
正解：A,B
解説: (Topexam メンバーにのみ表示されます)