Alcatel-Lucent 4A0-M02 問題集

質問 1：
Based on the information shown in the exhibit, which of the following is the PLMN ID?

A. 302720
B. 30201613
C. 720
D. 9876543
E. 302
F. 123456789
正解：A

質問 2：
In an LTE network, which of the following is used to carry the GTP message "Create Session Request"?
A. None of the above answers are correct.
B. Either the GTFV1 protocol or the GTPv2 protocol.
C. Both the GTPv1 and the GTPv2 protocols.
D. The GTPv2 protocol.
E. The GTPv1 protocol.
正解：D

質問 3：
On an Alcatel-Lucent 7750 MG, which of the following best describes the protect-active-delay timer configured for an MG-ISM group?
A. This timer indicates the time that the working card waits before it declares itself active after an MG-ISM switchover to the protection card has been performed.
B. This timer indicates the time that the working card waits before it declares itself active after a node restart.
C. This timer indicates the time that the protection card waits before it declares itself active during an MG-ISM switchover.
D. This timer indicates the time that the protection card waits before it declares itself active if the working card does not come up after a node restart.
正解：D

質問 4：
Which of the following statements is FALSE regarding the S1-based handover?
A. The SGW may be relocated.
B. None of the above statements are false.
C. The MME may be relocated.
D. Direct data forwarding via the X2 interface may be used.
E. Indirect data forwarding via the SGW may be used.
正解：B

質問 5：
On an Alcatel-Lucent 7750 PGW, which of the following is a mandatory step required to set up a Diameter connection to a PCRF server?
A. Create a Diameter profile.
B. Create a Diameter Peer profile.
C. Only answers B and D are required.
D. Assign the Diameter profile to the Diameter Peer profile
E. All of the above answers are required.
F. Assign the Diameter Peer profile to the Gx interface.
正解：C

質問 6：
Which of the following is the message used to detect a transport failure over a Diameter connection?
A. The Disconnect-Peer message
B. The Device-Watchdog message
C. The Credit-Control message
D. None of the above answers are correct
E. The Capabilities-Exchange message
正解：B

質問 7：
Which of the following statements is TRUE when the Alcatel-Lucent 7750 MG receives a GTP packet that has a zero TEID?
A. None of the above answers are correct.
B. The ingress IOM forwards the packet to the CPM for further processing.
C. The ingress IOM forwards the packet directly to the MG-ISM module for further processing.
D. The ingress IOM drops the packet.
E. The Alcatel-Lucent 7750 MG forwards the packet to its IP destination by looking into the local IP routing table.
正解：B