GB0-341-ENUの無料問題集（270題）、GB0-341-ENU認定試験参考書

H3C GB0-341-ENU 問題集

試験コード：GB0-341-ENU

試験名称：H3CSE-WLAN

最近更新時間：2024-05-05

問題と解答：全270問

GB0-341-ENU 無料でデモをダウンロード：

PDF版 Demo ソフト版 Demo オンライン版 Demo

無料問題集GB0-341-ENU 資格取得

質問 1：
Which of the following statements are correct about wireless network roaming? (Multiple choice)
A. Some terminals will automatically switch to other SSIDs when the current SSID link quality is poor. This is also roaming. As long as different SSIDs are managed by the same AC, the service will not be interrupted.
B. When STA roams between different APs, the network side needs to ensure that the IP address, VLAN information, etc. remain unchanged
C. In the case of Layer 3 roaming, the controller AC is needed to realize the inheritance of VLAN information, so the FAT fat AP scenario does not support Layer 3 roaming.
D. The roaming handover is finally initiated by the STA, and the STA will comprehensively weigh whether it needs to initiate roaming according to the signal strength and link quality.
正解：A,B,C,D

質問 2：
WLAN "Theoretical Maximum Transmission Rate" usually refers to the transmission rate of large-byte (0 1500 bytes) packets, but in most networks, there are more small-byte (below 250 bytes) packets. Will seriously affect the actual application performance of WLAN, making it far below the theoretical maximum rate.
A. False
B. True
正解：B

質問 3：
If you use the "display wlan ap all" command on the AC to see that the AP repeatedly enters the image download state, what are the possible reasons? (Multiple choice)
A. There is not enough space on the FIT AP device to store the downloaded new software version
B. The FIT AP software version placed on the AC does not match the AC software version
C. The serial number or model information of the FIT AP template on the AC is incorrectly configured
D. There is no software version of FIT AP on AC
正解：A,B,C,D

質問 4：
Since WDS is not clearly specified in the 802.11 protocol, AP equipment from various manufacturers is WDS interoperable.
A. False
B. True
正解：A

質問 5：
When the H3C AP is directly connected to a wireless switch or connected through a Layer 2 network, the correct registration steps are?
1. The AP sends out a Layer 2 broadcast discovery request message to try to contact a wireless switch
2. The AP downloads the latest software version and configuration from the wireless switch
3. The wireless switch that receives the discovery request message will check whether the AP has the permission to access the machine, and if so, it will respond with a discovery response
4. The AP obtains an IP address through the DHCP server
5. The AP starts to work normally and exchanges user data packets with the wireless switch
A. 14235
B. 41235
C. 12345
D. 41325
正解：D

質問 6：
What are the types of linear polarization directions of antennas?
A. Length or width
B. Left or right
C. Vertical or horizontal
D. Before or after
正解：C

質問 7：
What are the significance of network surveys? (Multiple choice)
A. Reduce maintenance costs in the future
B. Improve equipment ratio efficiency and protect customer investment
C. Realize the wireless network to best meet the needs of customers
D. Know the installation on site
正解：A,B,C,D

質問 8：
Which of the following statements about the use of the g debugging command is correct? (Multiple choice)
A. Try to use it during the low peak period of network usage or when there are few network users to reduce the impact of debugging commands on the system
B. Use certain debugging commands only when looking for certain types of traffic or faults and the cause of the fault has been narrowed down to a possible range. This can reduce the impact of debugging commands on device performance on the one hand, and on the other hand Reduce the output of a lot of useless information, which is conducive to more rapid fault location
C. Because the debugging commands occupy different system resources in each output direction, depending on the network load, we should choose between ease of use (info-center console debugging command) and low resource consumption (info-center logbuffer debugging command) Out of balance
D. Do not use the debugging command lightly without fully grasping the working process of the debugging command and the information it provides
E. The debugging command should be used to find faults, not to monitor normal network operation
正解：A,B,C,D,E

弊社は失敗したら全額で返金することを承諾します

我々は弊社のGB0-341-ENU問題集に自信を持っていますから、試験に失敗したら返金する承諾をします。我々のH3C GB0-341-ENUを利用して君は試験に合格できると信じています。もし試験に失敗したら、我々は君の支払ったお金を君に全額で返して、君の試験の失敗する経済損失を減少します。

弊社のH3C GB0-341-ENUを利用すれば試験に合格できます

弊社のH3C GB0-341-ENUは専門家たちが長年の経験を通して最新のシラバスに従って研究し出した勉強資料です。弊社はGB0-341-ENU問題集の質問と答えが間違いないのを保証いたします。

この問題集は過去のデータから分析して作成されて、カバー率が高くて、受験者としてのあなたを助けて時間とお金を節約して試験に合格する通過率を高めます。我々の問題集は的中率が高くて、100％の合格率を保証します。我々の高質量のH3C GB0-341-ENUを利用すれば、君は一回で試験に合格できます。

安全的な支払方式を利用しています

Credit Cardは今まで全世界の一番安全の支払方式です。少数の手続きの費用かかる必要がありますとはいえ、保障があります。お客様の利益を保障するために、弊社のGB0-341-ENU問題集は全部Credit Cardで支払われることができます。

領収書について：社名入りの領収書が必要な場合、メールで社名に記入していただき送信してください。弊社はPDF版の領収書を提供いたします。

TopExamは君にGB0-341-ENUの問題集を提供して、あなたの試験への復習にヘルプを提供して、君に難しい専門知識を楽に勉強させます。TopExamは君の試験への合格を期待しています。

弊社は無料H3C GB0-341-ENUサンプルを提供します

お客様は問題集を購入する時、問題集の質量を心配するかもしれませんが、我々はこのことを解決するために、お客様に無料GB0-341-ENUサンプルを提供いたします。そうすると、お客様は購入する前にサンプルをダウンロードしてやってみることができます。君はこのGB0-341-ENU問題集は自分に適するかどうか判断して購入を決めることができます。

GB0-341-ENU試験ツール：あなたの訓練に便利をもたらすために、あなたは自分のペースによって複数のパソコンで設置できます。

一年間の無料更新サービスを提供します

君が弊社のH3C GB0-341-ENUをご購入になってから、我々の承諾する一年間の更新サービスが無料で得られています。弊社の専門家たちは毎日更新状態を検査していますから、この一年間、更新されたら、弊社は更新されたH3C GB0-341-ENUをお客様のメールアドレスにお送りいたします。だから、お客様はいつもタイムリーに更新の通知を受けることができます。我々は購入した一年間でお客様がずっと最新版のH3C GB0-341-ENUを持っていることを保証します。

H3CSE-WLAN 認定 GB0-341-ENU 試験問題:

1. H3C wireless controller supports a variety of authentication methods, including ____. (Multiple choice)

A) MAC authentication
B) Portal authentication
C) PSK authentication
D) PPPOE authentication
E) 802.1X authentication

2. When performing a traffic test on an AP, which of the following software will have an impact on AP performance?

A) Microsoft Wireless Zero Configuration
B) Ethereal
C) SecureCRT
D) Network Stumbler

3. The wireless client can search for WLAN signals but cannot associate with the AP. What are the possible reasons? (Multiple choice)

A) The encryption method of the client's wireless network card is inconsistent with the AP
B) There are strong interference sources in the surrounding environment
C) Too many users associated with the AP
D) The AP is too far away or there are too many obstacles, and the signal strength is lower than the receiving sensitivity of the wireless network card

4. Which of the following device's power consumption is greater than 12.95w, traditional 802.11af devices cannot pass PoE and need to be powered by 802.3at or a local power supply?

A) WA2620E-AGN
B) WA2200-AG
C) WA2610E-AGN
D) WA2200X-AG

5. When using AP for wireless bridging, you need to pay attention to ______. (Multiple choice)

A) Whether the distance between APs is appropriate and whether there are obstacles in the middle
B) Two APs must work on the same channel
C) The local AP correctly configures the MAC address of the opposite AP, that is, peer-mac
D) If the antenna angles at both ends aligned or not

質問と回答：

質問 # 1
正解： A、B、C、D、E

質問 # 2
正解： B

質問 # 3
正解： A、B、C、D

質問 # 4
正解： A

質問 # 5
正解： A、B、C、D