HACKER SAFEにより証明されたサイトは、99.9%以上のハッカー犯罪を防ぎます。
カート(0

CompTIA RF0-001 問題集

RF0-001

試験コード:RF0-001

試験名称:RFID+ Certification

最近更新時間:2024-05-04

問題と解答:全162問

RF0-001 無料でデモをダウンロード:

PDF版 Demo ソフト版 Demo オンライン版 Demo

追加した商品:"PDF版"
価格: ¥5999 

無料問題集RF0-001 資格取得

質問 1:
When installing a dock door interrogator system, which of the following should be done after installation?
A. Assignment of network addresses.
B. Installation of interrogator power.
C. Testing for interference.
D. Backend application testing.
正解:D

質問 2:
Which of the following is the maximum output power of the interrogator at the connector between the interrogator and the antenna according to Federal Communication Commission (FCC) rules for 902-928 MHz RFID?
A. One watt
B. 4 watts
C. 100 milliwatts
D. 500 milliwatts
正解:A

質問 3:
A large number of antennas are being damaged at the dock doors of an existing installation. Upon further inspection, the technician discovers that forklift operators are hitting the antennas because they are 2 inches (5 centimeters) in front of the protective pylons/ballards. Which of the following would be the BEST solution?
A. Re-install the antennas so they protrude into the travel path further than the dock stands.
B. Remove the dock stands and install them somewhere else in the operation.
C. Move the dock stands so they are further out of the travel path than the protective equipment installed.
D. Replace the dock stands with smaller, less obtrusive dock stands.
正解:C

質問 4:
In a conveyor application, which of the following would be MOST important for getting consistent reads?
A. Slowing down the conveyor until the read rate is acceptable.
B. Angling the antennas to increase the time the tag is in the interrogation zone.
C. Speeding up the conveyor.
D. Adding an additional interrogator to increase coverage.
正解:B

質問 5:
The technician is preparing to place the light break sensor for a dock door interrogation zone. Based on the following diagram, in which of the following numbered locations should the light break sensors be placed? (Select TWO).

A. 3
B. 4
C. 6
D. 5
正解:A,B

質問 6:
A few months after installing an active Real Time Locating System (RTLS) in a warehouse, several of the tags stop working. Which of the following is MOST likely the reason?
A. The active tag was queried too often or set to transmit too often.
B. The tags were placed too close to each other causing shadowing and coupling.
C. The interrogator's frequency has inadvertently changed.
D. The tag's frequency was inadvertently changed.
正解:A

質問 7:
A passive ultra high frequency (UHF) RFID system reading cartons on a conveyor stopped working when the conveyor speed was increased. Which of the following would be the FIRST action to take to adapt the system to high-speed operation?
A. Move the light sensor away from the direction of travel.
B. Increase the interrogator power.
C. Add antennas to increase the time tags are in the interrogator field.
D. Rotate the antennas to point toward the cartons as they travel.
正解:D

TopExamは君にRF0-001の問題集を提供して、あなたの試験への復習にヘルプを提供して、君に難しい専門知識を楽に勉強させます。TopExamは君の試験への合格を期待しています。

弊社のCompTIA RF0-001を利用すれば試験に合格できます

弊社のCompTIA RF0-001は専門家たちが長年の経験を通して最新のシラバスに従って研究し出した勉強資料です。弊社はRF0-001問題集の質問と答えが間違いないのを保証いたします。

RF0-001無料ダウンロード

この問題集は過去のデータから分析して作成されて、カバー率が高くて、受験者としてのあなたを助けて時間とお金を節約して試験に合格する通過率を高めます。我々の問題集は的中率が高くて、100%の合格率を保証します。我々の高質量のCompTIA RF0-001を利用すれば、君は一回で試験に合格できます。

弊社は失敗したら全額で返金することを承諾します

我々は弊社のRF0-001問題集に自信を持っていますから、試験に失敗したら返金する承諾をします。我々のCompTIA RF0-001を利用して君は試験に合格できると信じています。もし試験に失敗したら、我々は君の支払ったお金を君に全額で返して、君の試験の失敗する経済損失を減少します。

弊社は無料CompTIA RF0-001サンプルを提供します

お客様は問題集を購入する時、問題集の質量を心配するかもしれませんが、我々はこのことを解決するために、お客様に無料RF0-001サンプルを提供いたします。そうすると、お客様は購入する前にサンプルをダウンロードしてやってみることができます。君はこのRF0-001問題集は自分に適するかどうか判断して購入を決めることができます。

RF0-001試験ツール:あなたの訓練に便利をもたらすために、あなたは自分のペースによって複数のパソコンで設置できます。

一年間の無料更新サービスを提供します

君が弊社のCompTIA RF0-001をご購入になってから、我々の承諾する一年間の更新サービスが無料で得られています。弊社の専門家たちは毎日更新状態を検査していますから、この一年間、更新されたら、弊社は更新されたCompTIA RF0-001をお客様のメールアドレスにお送りいたします。だから、お客様はいつもタイムリーに更新の通知を受けることができます。我々は購入した一年間でお客様がずっと最新版のCompTIA RF0-001を持っていることを保証します。

安全的な支払方式を利用しています

Credit Cardは今まで全世界の一番安全の支払方式です。少数の手続きの費用かかる必要がありますとはいえ、保障があります。お客様の利益を保障するために、弊社のRF0-001問題集は全部Credit Cardで支払われることができます。

領収書について:社名入りの領収書が必要な場合、メールで社名に記入していただき送信してください。弊社はPDF版の領収書を提供いたします。

CompTIA RFID+ Certification 認定 RF0-001 試験問題:

1. Cases are going to be tagged and stored in a humid, high temperature area. Which of the following types of labels would be needed?

A) Direct thermal with gum adhesive.
B) Poly-coated with gum adhesive.
C) Paper with gum adhesive.
D) Poly-coated with water base adhesive.


2. Although the site diagram has points marked for locations of print-encode-apply printers, the MOST important thing needed to complete the mounting is:

A) knowing the load factor of the floor.
B) knowing the label orientation on each case.
C) having a large work area.
D) locating the WiFi access points.


3. A large number of antennas are being damaged at the dock doors of an existing installation. Upon further inspection, the technician discovers that forklift operators are hitting the antennas because they are 2 inches (5 centimeters) in front of the protective pylons/ballards. Which of the following would be the BEST solution?

A) Re-install the antennas so they protrude into the travel path further than the dock stands.
B) Remove the dock stands and install them somewhere else in the operation.
C) Move the dock stands so they are further out of the travel path than the protective equipment installed.
D) Replace the dock stands with smaller, less obtrusive dock stands.


4. The automotive industry has implemented more RFID tags in their automobile immobilizers than any other application. Which of the following is the dominant technology used?

A) 2.45 GHz UHF
B) 125 - 150 kHz low frequency (LF)
C) 860 - 960 MHz ultra high frequency (UHF)
D) 13.56 MHz high frequency (HF)


5. Printers should be installed to meet Electronic Product Code (EPC) compliance in manufacturing at the: (Select TWO).

A) finished case pack area.
B) receiving area.
C) palletization area.
D) delivery area.


質問と回答:

質問 # 1
正解: B
質問 # 2
正解: B
質問 # 3
正解: C
質問 # 4
正解: B
質問 # 5
正解: A、C

RF0-001 関連試験
JK0-014 - E2C/Jobs+ RFID+ Certification Exam
連絡方法  
 [email protected] サポート

試用版をダウンロード

人気のベンダー
Apple
Avaya
CIW
FileMaker
Lotus
Lpi
OMG
SNIA
Symantec
XML Master
Zend-Technologies
The Open Group
H3C
3COM
ACI
すべてのベンダー
TopExam問題集を選ぶ理由は何でしょうか?
 品質保証TopExamは我々の専門家たちの努力によって、過去の試験のデータが分析されて、数年以来の研究を通して開発されて、多年の研究への整理で、的中率が高くて99%の通過率を保証することができます。
 一年間の無料アップデートTopExamは弊社の商品をご購入になったお客様に一年間の無料更新サービスを提供することができ、行き届いたアフターサービスを提供します。弊社は毎日更新の情況を検査していて、もし商品が更新されたら、お客様に最新版をお送りいたします。お客様はその一年でずっと最新版を持っているのを保証します。
 全額返金弊社の商品に自信を持っているから、失敗したら全額で返金することを保証します。弊社の商品でお客様は試験に合格できると信じていますとはいえ、不幸で試験に失敗する場合には、弊社はお客様の支払ったお金を全額で返金するのを承諾します。(全額返金)
 ご購入の前の試用TopExamは無料なサンプルを提供します。弊社の商品に疑問を持っているなら、無料サンプルを体験することができます。このサンプルの利用を通して、お客様は弊社の商品に自信を持って、安心で試験を準備することができます。