VCE 210-030 問題集

質問 1：
You are setting up a FAST VP policy in a Vblock System 700. The pool space for each tier is 5 TB EFD,
1 0 TB FC, and 100 TB SAT
The storage group with the FAST policy applied has a total of 10 TB allocated. The FAST policy has a
setting of 10% EFD, 50% FC, and 100% SATA.
According to the FAST policy, how much EFD space is available for use?
A. 5 TB
B. 1 TB
C. 11.5 TB
D. 0.5 TB
正解：B

質問 2：
Which two types of drives will a 25-drive DAE 2.5" drive accommodate? (Choose two.)
A. EFD
B. NL-SAS
C. SAS
D. SATA
正解：A,C

質問 3：
You are asked to zone a new four-node cluster on a Vblock System 340.
After adding the FC alias for the hosts, what are the next three steps you must do to configure the zoning
of these new hosts? (Choose three.)
A. Zone the hosts to all available VNX FA ports.
B. Add the new zones to the active zoneset.
C. Activate the zoneset and commit.
D. Zone the hosts to the appropriate VMAX FA ports.
E. Zone the hosts to the appropriate VNX FA ports.
正解：B,C,E

質問 4：
You are planning the upgrade of a VCE Vblock System 340 VNX block-only array and you need to assess
if the array is in a healthy state.
Which three actions should you perform to validate the system? (Choose three.)
A. Verify all host initiators under Host Connectivity in Unisphere show as logged in.
B. Generate sp_collects from both SPs.
C. Check for trespassed LUNs.
D. Verify the primary Xblade status.
E. Verify that both Control Stations are up.
正解：A,B,C

質問 5：
Which storage software is installed on the VCE element management server to manage, monitor, and
configure VNX storage systems?
A. ESRS
B. DCNM
C. UIM/P
D. Unisphere
正解：D

質問 6：
During a Vblock System 340 deployment, a customer asks you to change the IP address on both Control
Stations from the original LCS configuration.
Which process accomplishes this?
A. Failover Storage Processor A, to Storage Processor B, then change the IP address on the primary
Control Station first, then move to the Secondary, and fail back the secondary.
B. Change the IP address on the Primary Control Station, verify using specified NAS commands, failover
the Primary Control Station to the Secondary, and change its IP address and fail back the secondary.
C. Failover Storage Processor B, to Storage Processor A, then change the IP address on the primary
Control Station first, then move to the Secondary, and fail back the secondary.
D. Change the IP address on the Secondary Control Station, verify using specified NAS commands,
failover the Secondary Control Station to the Primary, and change its IP address and fail back the primary.
正解：B