IBM C2150-561 問題集

質問 1：
Where is the segment's mode configured in the Local Management Interface?
A. from the Secure Protection Settings, select Security Interfaces
B. from the Manage Systems Settings, select Security Interfaces
C. from the Network Dashboard, right-click on the segment, select Mode, and click Deploy
D. from the Home Dashboard, right-click on the segment, select Mode, and click Save
正解：B

質問 2：
Which method upgrades the firmware?
A. PXE boot
B. Configuration Menu via SSH
C. Trivial File Transfer Protocol (TFTP)
D. Web interface
正解：D

質問 3：
Where would a user be added to allow a remote user to access the IBM Security Network Intrusion Prevention System V4.3 Local Management Interface?
A. the Accounts and Passwords page in the Web interface
B. the User Management utility in SiteProtector
C. the Password Management menu in the SSH Configuration menu
D. the Remote Access policy in IBM Security SiteProtector System (SiteProtector)
正解：A

質問 4：
The IBM Security Network Intrusion Prevention System V4.3 is not registering with IBM Security SiteProtector System (SiteProtector). Where in the Local Management Interface (LMI) can potential connection issues be corrected?
A. If the SiteProtector Management option was selected during the initial installation, SiteProtector communications settings cannot be changed in the LMI.
B. On the SiteProtector Management page, confirm Register with SiteProtector has been selected and review the Agent Manager Configuration settings.
C. Select Telnet under System Tools and telnet to the Agent Manager IP using port 3995.
D. Under Management and TCP Reset Interfaces, check to see that both ports 443 and 3995 are enabled.
正解：B

質問 5：
An administrator has reimaged an IBM Security Network Intrusion Prevention System V4.3 (Network IPS) without unregistering it from IBM Security SiteProtector System (SiteProtector) and has reconfigured it identically. It has resulted in duplicate agents listed in the Agent view in SiteProtector with one of them in offline status. Why?
A. When an agent heartbeats in, it will register the device as a new agent even if SiteProtector has already registered it.
B. SiteProtector uses the agent name to recognize the Network IPS device and when the name changes it is registered as a new device.
C. SiteProtector uses an agent GUID to recognize Network IPS devices and when this GUID changes it is registered as a new device.
D. When an agent heartbeats in, SiteProtector does not check to see if the agent already exists before adding it as an agent.
正解：C

質問 6：
Which Response Object would be configured in order for the appliance to send notifications to individuals or groups when events occur?
A. Quarantine
B. e-mail
C. SMS
D. Log Evidence
正解：B

質問 7：
What is the correct cabling option (transceiver) that can be implemented in a GX7800 appliance?
A. The first four segments are 10G LR/SR and the others must be for a 1G network.
B. All ports can be for a 1G network.
C. Copper 1G cabling is not supported.
D. All ports must be a mix of 10G LR and SR transceivers.
正解：B

質問 8：
Where is the block response of a specific IBM Protocol Analysis Module signature modified?
A. Security Events
B. Firewall Rules
C. Response Objects
D. Open Signatures
正解：A

質問 9：
An administrator wants to inspect e-mail traffic on a specific protection domain that is being sent to a specific e-mail address. Which policy meets this requirement?
A. Security Events
B. Firewall Rules
C. User Defined Events
D. Connection Events
正解：C