Network Appliance NS0-171 問題集

質問 1：
You are an administrator of a UCS system. You notice that when you apply a setting that requires a reboot, the affected hardware reboots immediately without warning. You would like to reboot to be acknowledged by an administrator instead.
What should you do to accomplish this task.
A. Create aa BIOS policy.
B. Create a scrub policy.
C. Create a maintenance policy.
D. Create updating templates.
正解：B

質問 2：
You are asked to configure the computer resources in a FlexPod solution to ensure that jumbo frames are configured end-to-end.
Which three actions must you perform to accomplish this task? (Choose three.)
A. Set the MTU size to 1500 on the vNIC template
B. Enable jumbo frames on all of the switches between the initiator and the iSCI target.
C. Enable jumbo frames on the operating system adapter.
D. Configure jumbo frames on the switch VLANs.
E. Configure a UCS QoS System Class with the jumbo frames.
正解：B,C,E

質問 3：
An administrator is deploying a FlexPod solution for use with VMware vSphere 6.0.
The storage environment consists of a two-node AFF8040 cluster running clustered Data
ONTAP 8.3 with a single DS2246 disk shelf fully populated with 800 GB SSD drives.
The system is configured to use Advanced Drive Partitioning (ADP).
The administrator wants to ensure that each node is configured with the same amount of recourses while also using hot spares for resiliency.
In this scenario, how many total disk partitions will each node have available for the data aggregate?
A. 12
B. 8
C. 11
D. 22
正解：B

質問 4：
Click the Exhibit button.

You just finished cabling a UCS 5108 chassis to the Fabric Interconnects.
Which diagram in the exhibit is cabled correctly according to the CVD guidelines?
A. I
B. III
C. II
D. IV
正解：D

質問 5：
Which LIF role is used for SnapMirror traffic on a system running clustered Data ONTAP?
A. node-management
B. intercluster
C. interconnect
D. cluster-management
正解：B

質問 6：
An administrator has a FlexPod solution with VMware vSphere. The administrator is migrating all network traffic from standard switches to vSphere distributed switches. Virtual machines (VMs) are currently using VM port groups called VLAN_500 and VLAN_501 on standard virtual switch vSwitch3. A new distributed switch called dvSwitch_VM is created and new distributed port groups are configured for each VM traffic VLAN. VMs are configured to use the new port groups. After the change, VMs on VLAN 501 report a loss of network connectivity; however, VMs on VLAN 500 are not showing any connectivity issues.
The symptoms are experienced for VMs on all ESXi hosts.
Which action must the administrator perform to solve the problem?
A. Create a new vmkernel port on dvSwitch_VM for VLAN 501.
B. Add the correct VLAN ID to the new distributed port group for VLAN 501.
C. Configure the dvSwitch_VM port binding to Ephemeral.
D. Reboot the virtual machines to re-establish network connectivity.
正解：C