Network Appliance NS0-520 問題集

質問 1：
How do you configure the iSCSI-SendTargets datastore when the datastore is provisioned from NetApp storage?
A. You must configure a single protocol on the SVM when SendTargets-based iSCSI is used.
B. You must configure jumbo frames when SendTargets-based iSCSI is used.
C. Use dynamic discovery to add the target IQN.
D. Use static discovery to add the target IQN.
正解：C

質問 2：
An administrator has an AFF A200 cluster at their primary site that is used for FC connectivity to servers. For disaster recovery purposes they want to start replicating their data to another AFF A3Q0 cluster In a secondary location. The AFF A300 is In a site that has no FC or FCoE capable switches, and is currently only used for CIFS dat a. A cluster peering relationship already exists between the two clusters.
Which three additional actions are needed for the data to be ready for access from hosts at the secondary site? (Choose three.)
A. Create new iSCSI igroups for LUN mapping.
B. Enable the iSCSI service on the SVM at the secondary site.
C. Enable the iSCSI service on the SVM at the primary site.
D. Replicate the data from the primary site to the secondary site with SnapMirror.
E. Create zones with the appropriate initiators and targets for the secondary site.
正解：A,B,D

質問 3：
You are planning to set up a new SAN with an AFF A300 2-node switchless cluster. Your SAN fabric will consist of Cisco MDS9148s switches.
According to NetApp best practices, which two actions would be required to accomplish this task? (Choose two.)
A. Set the switchport speed setting to 16 Gb.
B. Use multiple initiator, single target zoning.
C. Use single initiator, multiple target zoning.
D. Set the switchport speed to auto negotiate.
正解：C,D

質問 4：
Exhibit.

An administrator has an AFF A200 HA pair.
Referring to the exhibit, how many 10 Gbps connections would the customer have on a single node for SAN host connectivity?
A. 2
B. 4
C. 6
D. 7
正解：B

質問 5：
You want to move a SAN LIF and preserve its configuration information and avoid rezoning the switch fabric. In this scenario, which two steps must be performed to fulfill this goal? (Choose two)
A. Move the SAN LIF to another node in a cluster on existing storage virtual machine (SVMs)
B. Take the SAN LIF offline before it is moved
C. Move the SAN LIF to another node in a cluster on a different storage virtual machine (SVMs)
D. Keep the SAN LIF online before it is moved
正解：A,B
解説: (Topexam メンバーにのみ表示されます)

質問 6：
You currently have a FAS8200 with ONTAP 9.5. You want to expand the front end FC I/O capabilities. However, you are unsure which target adapters are supported.
What would you use to confirm which adapters are supported with your current configuration?
A. Upgrade Advisor
B. Hardware Universe (HWU)
C. Interoperability Matrix Tool (IMT)
D. OneCollect
正解：B

質問 7：
After the addition of extra DS224C disk shelves, you notice that the output of the system node run -node node_1 sysconfig command shows Mixed-path. You need to investigate why the additional shelves are providing this error.
In this scenario, which two tools would help diagnose this issue? (Choose two.)
A. Config Advisor
B. Active IQ
C. Hardware Universe (HWU)
D. Interoperability Matrix Tool (IMT)
正解：A,D