IBM 000-565 問題集

質問 1：
In IBM Tivoli Network Manager IP Edition V3.9 given a requirement to discover a new node but not place it in the topologycorrectly, which two tasks must be performed when doing partial rediscovery? (Choose two.)
A. ensure the option Network Discovery Configuration > Advanced > Enable Rediscovery Rebuild Layers is checked
B. ensure the option Network Discovery Configuration > Advanced > Enable Rediscovery of Related Devices is checked
C. ensure the option Network Discovery Configuration > Advanced > Enable Rediscovery Rebuild Layers is unchecked
D. ensure the necessary agents are enabled under Network Discovery Configuration > Partial Rediscovery Agents tab
E. ensure the option Network Discovery Configuration > Advanced > Enable Rediscovery of Related Devices is unchecked
正解：C,D

質問 2：
During a deployment, a customer has identified location data that they would like added to both chassis and interface events from active (IBM Tivoli Network Manager IP Edition V3.9 (ITNM)) and passive (traps, syslogetc.) event sources.
This data has been successfully imported into the Discovery process using supported stitching techniques and appears in the topology as three custom Extralnfo fields (see below).
ncpjnodel has been configured to transfer this locationdata to a custom extended NCIM database table named locations (see exhibit below). This data is only held on EntityType 1 (chassis entities) to reduce the NCIM load.
The customer has identified three ObjectServer fields that they would like this data:o be added to for all suitable events -NmosGeography, NmosCountry, and NmosSite

Example record in Model Description of the ncim.locations table

The ModelNcimDb configuration has been modified to map:

Based on the scenario, the location data isheld in NCIM at the chassis (EntityType 1) but not against each interface entity.
If an SNMP linkDown trap was received by the ObjectServer, could it be enriched with the location data held on the chassis?
A. No. An interface event cannot be related to the parent chassis by the gateway
B. Yes. Interface events can be enriched with chassis level data by the EventGateway
C. No. The data would need to be held at both the interface and chassis level to allow this enrichment
D. Yes. But only if the event is sent across the gateway for further root cause analysis and entity identification
正解：B

質問 3：
What does this IBM Tivoli Network Manager IP Edition V3.9 (ITNM) command do: ncp_dh_XML rpc?
A. It enables ITNM to communicate directly to EMS systems.
B. It reads the collector host seeds from a seed table in the collector Finder database andthen queries the collectors specified in this table to get a list of devices managed by the EMS.
C. It enables ITNM tocommunicate with the collectors using the XML-RPC interface.
D. It retrieves local neighbor and entity and associates address data for each device on the collector.
正解：C

質問 4：
What two typesof discoveries can be made using the graphical user interface? (Choose two.)
A. Fast Discovery
B. Total Discovery
C. Full Discovery
D. Half Discovery
E. Partial Discovery
正解：C,E

質問 5：
A Juniper J6300 router with anOID of 1.3.6.1.4.1.12532.253 has been introduced the network but there is no classification for this device. What ensures the device inherits all properties of the base Juniper class when added to the new AOC file?
A. instantiation_class ='Juniper'
B. sub_class ='Juniper1'
C. parent_class = 'Juniper1'
D. superclass ='Juniper'
正解：D

質問 6：
Which option verifies the availability of the seed list in IBM Tivoli Network Manager IP Edition V3.9?
A. in DiscoConfig.cfg set m_Ping Verification=1 under disco.config
B. in DiscoSchema.cfg set m_PingVerification=1 under disco.config
C. in DiscoConfig.cfg set m_CheckFileFinderReturns=1 under disco.config
D. in DiscoSchema.cfg set m_CheckFileFinderReturns=1 under disco.config
正解：C

質問 7：
Which two statementsare true about installing IBM Tivoli Network Manager IP Edition V3.9 (ITNMJ on a Solaris platform? {Choose two.)
A. The setup_setuid_as_root.sh script must be run as root if ITNM is installed and will run as non-root.
B. Multiple ITNM installations on the same server can be installed with both the root account and a non-root account.
C. If ITNM is installed as a non-root user, all future Tivoli products must be installed as the same user.
D. The setup_setuid_as_root.sh script must be run as non-root if ITNM is installed and will run as non-root.
E. The ITNM destination directory must be owned as root.
正解：A,C