Network Appliance NS0-592 問題集

質問 1：
Which two statements are true about a data volume? (Choose two.)
A. A data volume can be accessed by a user connected to any SVM.
B. A data volume can be moved to any aggregate with space for it in the cluster.
C. A data volume can be accessed by a LIF on any node.
D. An SVM root or root load sharing mirror volume must be present on every node.
正解：B,C

質問 2：
A customer calls you about a performance issue that they experienced over the past few days. They want to know if data collection and root cause analysis (RCA) is possible for this issue. This issue appears to be a one time event.
Which tool would be used to satisfy the customer's request?
A. perfstat
B. perfmon
C. Performance Archive
D. OneCollect
正解：D

質問 3：
The root aggregate on your single-node ONTAP cluster failed. You have the configuration backups saved on your FTP server?
In this scenario, which two steps are part of the recovery procedure? (Choose two.)
A. Perform a Netboot using the configuration backup.
B. Create a new root aggregate and set its ha_policy option to cfo.
C. Boot into maintenance mode.
D. Create a new aggregate and set its ha_policy option to sfo.
正解：B,C

質問 4：
Click the exhibit button.

Your customer added a new DS4246 shelf to their FAS system. They created an aggregate on the new shelf.
Two weeks later, they log in to Active IQ and discover the Medium Impact error shown below.
"Both SAS connections from one controller go to the same shelf."
Referring to the exhibit, which statement is correct?
A. You can correct this problem without downtime on the FAS system.
B. A faulty IOM is causing the problem.
C. A faulty cable is causing the problem.
D. You are unable to obtain a "Cable Visualization" overview from Active IQ.
正解：A

質問 5：
A customer has requested your assistance with replacing a DS224C disk shelf from their cluster nondisruptively.
Which two actions should be performed before physically replacing the shelf? (Choose two.)
A. Upgrade the IOMs in the shelf before starting the removal process.
B. Zero the disks before performing the physical shelf removal.
C. Verify that the system is configured as multipath high availability.
D. Verify that the drives in the shelves are spares and ownership is removed.
正解：C,D

質問 6：
Your customer states that the storage efficiency on their FAS 8200 is far below what they had expected for a VMware NFS datastore. They enabled deduplication three days ago. The job ran every night for only 10-20 minutes, and the space savings now is less than 5%.
What is causing the space savings to be so low?
A. They have enabled aggregate-level inline data compaction, so the savings are at the aggregate level.
B. They have not enabled volume-level compression.
C. They have not run a baseline deduplication to scan old data.
D. They have enabled aggregate-level inline deduplication, so the savings are at the aggregate level.
正解：B

質問 7：
You configured iSCSI multipathing on a Windows host to a 2-node ONTAP cluster so that you can attach to some LUNs. You see that the host logging in to both iSCSI LIFs in the ONTAP cluster, and you notice that the igroup is correctly set. After you open Disk Management and rescan for disks, the NetApp LUNs do not show up.
In this scenario, what should be performed to enable the LUNs to be visible to the Windows host?
A. Configure the ONTAP nodes for HA and try scanning again.
B. Set up LUN mapping and try scanning again.
C. Configure the SVM for FCP and try scanning again.
D. Set up Selective LUN Mapping (SLM) and try scanning again.
正解：D